NeBasicUNO

A very very basic basic for the Arduino Uno

Upload Open Code.c and upload it to the Arduino using Arduino IDE or similer

Commands

Command	Syntax	Description
PRINT / ?	PRINT <expr>	Prints a variable (A-Z) or literal integer.
LET	LET <A-Z> = <expr>	Assigns an integer or variable value to a target variable.
VARS	VARS	Displays all non-zero assigned variables.
CLEAR	CLEAR	Resets all variables (A-Z) to 0.
HIGH	HIGH <pin>	Sets a digital pin mode to OUTPUT and drives it HIGH.
LOW	LOW <pin>	Sets a digital pin mode to OUTPUT and drives it LOW.
TOGGLE	TOGGLE <pin>	Inverts the current digital state of a pin.
READ	READ <pin>	Configures a pin to INPUT_PULLUP and prints state (0 or 1).
AREAD	AREAD <pin>	Reads and returns the raw ADC value from an analog pin.
AWRITE	AWRITE <pin> <val>	Emits PWM signal (0-255) on a supported pin.
TONE	TONE <pin> <freq>	Generates a square wave of specified frequency (Hz) on a pin.
NOTONE	NOTONE <pin>	Stops frequency generation on a pin.
DELAY	DELAY <ms>	Pauses execution for the specified milliseconds.
RAND	RAND <var> <max>	Stores a random value from 0 to max - 1 into target variable.
PEEK	PEEK <addr>	Reads and displays the byte stored at a raw memory address.
POKE	POKE <addr> <val>	Writes a byte directly to a raw memory address.
FREE	FREE	Outputs remaining available SRAM in bytes.
HELP	HELP	Prints quick command syntax summary.

If you create a PR or Issue, I'm probably not going to see so I recommend just making a fork